Redmax BC4401DW User Manual download pdf (Page 20)

❲

20

❳

Maintenance

• Always be sure to stop the engine before

inspecting the brushcutter for problems

or performing maintenance.

• Never alter the brushcutter or take the

engine apart.

• When replacing parts, always be sure to

use only RedMax products or products

which have been certified by RedMax for

use with the RedMax brushcutter.

• Things to check before using

brushcutter

■ REFILLING TRIMMING LINE

1. For replacement line, use a diameter of

.095in (2.4mm). The spool is capable for a

line upto 27ft (8m) on the 4” head, and 46ft

(14m) on the 6” head. Avoid using a larger

line as it may cut down the trimming

performance. For safety reasons, do not

use metalreinforced line.

2. Pinch the slotted area on the both sides of

the spool housing to unhook the bottom

cap.

3. Take out the spool and pull off the old line.

Put one end of new line through the spool

holes and pull it until the length is equal

between each part of the line.

4. Wind up the line in the correct as indicated

on the spool.

WARNING

5. Hook each end of the line in the slot on

the edge of the spool, and then put the

ends through the eyelets on the housing.

Make sure that the spring and the washers

are in place.

6. While holding the spool against the

housing, pull the line ends to release them

from the slot.

7. Line up the slot on the bottom cap with the

hook on the housing, press the cap

against the housing until it clicks.

• Make sure that the engine has stopped

and is cool before performing any

service to the brushcutter. Contact with

moving cutting head or hot muffler may

result in a personal injury.

■ AIR FILTER

• The air filter, if clogged, will reduce the

engine performance. Monthly check and

clean the filter element in warm, soapy

water as required. Dry completely before

installing. If the element is broken or

shrunk, replace with a new one.

WARNING

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Comments to this Manuals

No comments